Ozarks Jeep Thing Club

Public Forums => Fabricators Forum => Topic started by: mindgame on 08/ 2/13 - 10:07AM

Title: dana hp30 build in progress
Post by: mindgame on 08/ 2/13 - 10:07AM

hello,  I'm  in the process of building a hp 30  out of a 2000 Cherokee.  First thing was throw out the carrier and gears, replacing with 4.88  gears, ARB 30 spline  locker,30 spline inner shafts, new ball  joints,  New lower control arm mounts,  and new  unit bearings.

Title: Re: dana hp30 build in progress
Post by: mindgame on 06/25/14 - 09:43PM

Ok, well learned that the 2000 Cherokees had a Lp30 so my 1999 Cherokee is the donor Hp30 and the Lp30 is going into the 1999 Cherokee, so far have the home out of old red and starting to pull old parts off of it first the unit hub bearings, next is the ball joints, then the Axel shafts, get rid of the gears, carrier, and replace the gears to 4.88 and replace the carrier with an ARB air locker with a 30 spline Axel shafts. 

Title: Re: dana hp30 build in progress
Post by: Reaniwy on 12/17/19 - 01:14AM

The story makes me very confused. You make it clear

Title: Re: dana hp30 build in progress
Post by: mindgame on 12/20/19 - 12:37AM

On my dana hp30  I've got a tnt truss on it, arb 30 spline locker, 4.88 gears, 30 spline Yukon inner shafts, outer axle seals.