Axle bearing and retainer pressing

[LoneWolf]

I have a leaky rear axle seal that I am in the process of replacing.

I have the axle out; old seal, bearing, and retainer I dremmeled off. Shaft is  cleaned prepped and ready for the new seal, bearing and retainer... However I have no way and no tricks up my sleeve to press them onto the shaft. Does anyone have the ability to do this? Can you tell me where I would get this done? OR share a shadetree mechanic tip so I can do it myself... ?

Thanks.

[LibertyPatriot]

You might try Kevin at 4Wheelers Supply.  I think he posted something about pressing bearings at his shop.

Keith

[LoneWolf]

Thanks Keith.. yes he can do pressing over there. That's good to know. However, by the time I am done buying bearings, seals, and retainers... Im going to be into close to $150, so I'm upgrading to Superiors.  Thanks to Kevin at 4ws.com for a great price.

[YJ_Aaron]

You have to love an upgrade that proves financially sensible.