Ozarks Jeep Thing Club
Public Forums => Technical Forum => Topic started by: kam5512 on 02/17/12 - 05:03PM
-
I getting it tonight for my 95yj. How hard will it
Be to put it in? What will I need as far as money
And parts? Any ideas? Thanks Kevin.
Oh ya I paid 150.00 for it. Was it a good deal?
I think so. I'm meeting him at St Johns at 6 pm.
If anyone wants to look at it for me to make sure
I'm not getting a bad deal. I don't know how to identify
What a 44 even looks like... :(
840-9486 is my number
-
If it's an XJ 44 that's not a bad deal. However it's not a bolt in by any means. I can go through all your options with it in person much easier than on here.
(http://www.cdmfabrication.com/bbpics/axlechart.jpg)
-
Print the pic above off and take it with you. Make sure the cover matches DANA 44 in the pic. Not 8.25 or dana 35!
With this as a reference you should be fine.
-
Can I send a pic to anyone to look at this and tell
Me what they think it is? It doesn't look exactly
Like a 44 or 35? But closer to a 35.
I think I just got screwed!! :(
-
Does it look like an 8.25? Those are the only 3 axles under XJ's.
-
It had some looks of both. I'm pretty sure it's a 35.
If your home I could swing by to show you.
-
Never mind. The guy called me back.
He is giving me my money back
-
I'm home if you want to swing by before you undo the deal.
-
Undid the deal at noon. I took it by my mechanic
And it was a 35.
-
you may want to start checking out the Ford 8.8 rear axle for your swap, with rear disc brakes. Plenty of info on Jeep forums and pretty low cost.
-
I will. And trust me when I say I will ask next time before I buy.... Lol