« previous next »
Pages: [1] |   Go Down

Author Topic: TJ Flares  (Read 1058 times)

Offline why jay

  • Level 2
  • **
  • Posts: 249
TJ Flares
« on: 11/ 1/07 - 01:49PM »
When I cut the sheet metal to put TJ flares on, some sites says that I will need to tack weld the sheet metal and others dont say anything about it.  Do I need to do this, and if so, any recommendations on where to have it done?  Thanks.

Jay
Logged
I am Joe the plumber.

Offline OJTV8CJ

  • Charter Members
  • Level 4
  • *
  • Posts: 843
Re: TJ Flares
« Reply #1 on: 11/ 1/07 - 02:06PM »
No.  Just trim it and drill some of the holes that don't line up.
Logged
I cut sheetmetal for free.  It's fixing it that get's expensive.

Offline why jay

  • Level 2
  • **
  • Posts: 249
Re: TJ Flares
« Reply #2 on: 11/ 1/07 - 02:29PM »
okay, thanks
Logged
I am Joe the plumber.
Pages: [1] |   Go Up
« previous next »